高层地下室底板混凝土施工的裂缝控制

以德益花园写字公寓楼地下室底板205m厚混凝土的施工工程为例，坚持预防为主的原则，采取了一系列温控技术措施，有效地防止或控制了温度裂缝(收缩裂缝)的产生，确保了混凝土的施工质量。     

半流体润滑脂在抽油机减速箱保养中的应用

抽油机减速箱的润滑和漏失问题已经严重影响了抽油机的正常运转，引起了人们的重视。为了解决这个问题，中原油田分公司采油一厂应用了由燕化集团生产的半流体润滑脂，先后应用于20台抽油机减速箱的润滑保养，通过6个月应用与监测，发现该半流体脂的润滑及防漏效果良好。     

对称配筋小偏心受压构件的截面设计

对小偏心受压构件在对称配筋情况下的截面配筋计算，提出用最佳一次逼近多项式简化基本公式，直接按二次方程求解ξ的近似方法，具有精度高，相对误差小，计算方便等优点，可供工程设计人员参考。     

碾压混凝土坝应力场有限元及施工仿真分析

采用三维有限元法对某碾压混凝土坝(RCC)在施工导流期的应力场进行分析,着重校核了顶部未到设计龄期的碾压混凝土和大型导流底孔周边的应力分布;并初步探讨了在多因素影响情况下,从开始施工到蓄水运行的坝体温度场、应力场的全过程仿真分析方法。     

高温季节大体积混凝土基础施工的裂缝控制

文章以上海富华大厦工程为例,对在高温季节如何针对大体积混凝土基础施工的裂缝进行控制,提出了相关措施,达到了控制裂缝的预期目标。     

影响混凝土强度的因素及控制措施

分析了水泥强度等级、水灰比和骨料质量等内因,及施工条件、养护温度、湿度、龄期等外因对混凝土强度的影响,并提出了控制混凝土强度的相应措施,以确保混凝土强度符合设计及施工要求,从而保证建筑物结构安全。     

Effects of Seismically Induced Pounding at Expansion Joints of Concrete Bridges

This paper presents the result of a study on the effect of pounding at expansion joints on concrete bridge response to earthquake ground motions. An engineering approach, rather than continuum mechanics approach, is emphasized. First, the dynamic behavior of a damped multidegree-of-freedom bridge system separated by an expansion joint involving an impact is examined by means of the finite element method. Second, the sensitivity analysis of the stiffness in gap elements is performed. Third, usefulness of the analysis method for simulation of pounding phenomena is demonstrated and the effect of pounding on the ductility demands measured in terms of the rotation of column ends is investigated. Two-dimensional finite element analysis using a bilinear hysterestic model for bridge substructure joints and a nonlinear gap element for the expansion joint is performed on a realistic bridge with an expansion joint. The effects of the primary factors on the ductility demand such as gap sizes and characteristics of earthquake ground motion are investigated through a parametric study. The major conclusions are (1) the effect of impact most directly depends on the size of momentum (or pounding magnitude); and (2) the pounding effect is generally found to be negligible on the ductility demand for wide practical ranges of gap size and peak ground acceleration, but is potentially significant at the locations of impact.     

某铁路医院加速器室大体积防射线混凝土施工

结合大同铁路分局中心医院直线加速器室工程实际，介绍了大体积防射线混凝土的特点及施工中应注意的事项，并阐述了具体的施工技术。     

应用金属迭片挠性联轴器改造D1000-32型风机

使用液力偶合器因故障频繁，对高炉稳产、高产造成严重威胁，而且维修费用较高，对偶合器改造后，应用金属迭片挠性联轴器其故障率、维修费用都很低。     

A p‐version,first order shear deformation,finite element for geometrically non‐linear vibration of curved beams

A p‐version, hierarchical finite element for curved, moderately thick, elastic and isotropic beams is introduced. The convergence properties of the element are analysed and some results are compared with results published elsewhere or calculated using a commercial finite element package. It is verified that, with the proposed element, shear locking does not affect the computation of the natural frequencies and that low dimensional, accurate models are obtainable. Geometrically non‐linear vibrations due to finite deformations, which occur for harmonic excitations with frequencies close to the first three natural frequencies of vibration, are investigated using Newmark's method. The influence of the thickness, longitudinal inertia and curvature radius on the dynamic behaviour of curved beams are studied. Copyright © 2004 John Wiley & Sons, Ltd.